| P R O D U C T S | T Y P E |
| ■ MOLD RELEASE AGENT | ●GENERAL ●HEAT RESISTANT |
| ■ ANTI RUST AGENT | ●SHORT TERM ●MIDDLE TERM ●LONG TERM |
| ■ CLEANING AGENT | ●GENERAL ●STORONG ●GAS & TAR REMOVER |
| ■ LUBRICANT AGENT | ●DRY ●OIL ●GREASE ●LIQUID |
| ■ SURFACE TREATMENT | ●SURFACE TREATMENT ●ANTI STATIC ●COATING |
| ■ OTHER / OEM ODM | ●OTHER ●OEM ODM |
PIN CARE NEXT
This product is dry type lubricant with thin film. It is the best lubricant for applies to the shaping part like the ejector pin, slide parts, etc. that you are worry about the stain.
Also, it can be used under severe temperature conditions.
| Feature | Ingredients | Regulation |
| Heat-resistant 300℃, Sticky is few Pressure performance is excellent Sustained perfomance is good | Special synthetic oil Lubricating additives Hydrocarbon solvent, LPG | Class 2.1 UN1950 |
J1
This product is dry lubricant with contains PTFE, it is suitable for applied to the moveable part that do not want to be dirty.
To compare with PINCARE NEXT, effectiveness is weaker than, but the stickiness and blot is very little.
| Feature | Ingredients | Regulation |
| Sticky is few Few bad influence to plastics Heat resistant 250℃ | PTFE, Petrolatum, Aditives Hydrocarbon solvent, LPG | Class 2.1 UN1950 |
MOULD HELPER
This product is dry type lubricant with contains PTFE. So, the stickiness and blot is very little.In additional, it contains anti-rust component, so able to applied to the moveable part without dirty.
It has hardly effect on plastic.
| Feature | Ingredients | Regulation |
| Sticky is few, Containing antirust Few bad influence to plastics Heat resistant 250℃ | PTFE, Petrolatum, Aditives Hydrocarbon solvent, LPG | Class 2.1 UN1950 |
WHITE LUB SPRAY
This product is a spray of White Lub F.
It is suitable for applied to the moveable part that do not want to be dirty.
| Feature | Ingredients | Regulation |
| Chlorne free, Non-flammable Higly safe and non-toxic Ozon depleting potential 0 | Fluorine oil, PTFE Fluorine solvent, LPG | Class 2.1 UN1950 |
FLUO LUB
A dry film lubricant in which a fluoropolymer is dispersed in a fluorine-based solvent. Ideal for lubrication of areas such as die ejector pins and slides where oil adhesion is not desired.
It can also be used for the following purposes.
○Lubrication of sliding parts and gears of electronic devices, office automation equipment, home appliances, automobile interior parts, etc.
○Prevention of squeaking noise at parts joint
○Lubrication of various bearings
○Lubrication for contact switches: Does not generate insulating material due to high temperature and discharge found in Si
○Masking: Masking for film capacitor deposition
○Sealant: Sealant with inert fluid
○Excellent in optical properties with low refraction such as antifouling coating and fingerprint prevention
○Mold release when molding various resins and rubber
| Feature | Ingredients | Regulation |
| Dry lubrication film No impact on rubber / plastic Non-flammable and highly safe | Fluoropolymer Fluorine solvent | None |